Whale Smartflo On Board Pump (Pageant & Senator); Priming The System Using The External Water Container (Pageant & Senator) - Bailey Caravan Owner's Manual

3
Caravan Service Systems
3.1.3 Whale Smartflo On Board
Pump (Pageant & Senator)
Operation
Valves:
Both the manual valves included in this
system must be positioned appropriately
(fig 1-3) when switching between the
three functions of the water system; using
an external water supply, filling the
onboard tank and using the onboard
tank.
3.1.4 Priming the System using
the External Water Container
(Pageant & Senator)
1. Position the valves as shown in fig.
1 (Senator configuration only).
2. Adjust dust cover over water
container opening (please note dust
cover should not be secured to
water container as air must be
allowed to enter container to replace
water being drawn out).
3. Open one cold tap (e.g. kitchen
sink).
4. Place carbon filter assembled to
hose, into a full water container.
5. Insert plug into wall socket and close
lid to lock plug in place (see fig. 5).
6. Switch on 12 volt supply at main
control panel located by the exterior
door.
7. Water will flow from the open tap
expelling any trapped air in a few
seconds. The water may at first be
greyish in colour which is quite
normal, the discolouration is due to
harmless media being flushed out
of the new filter cartridge.
8. Close cold tap and open hot tap to
expel any remaining air in the water
heater (this may take up to 30
seconds). Then repeat this exercise
with the remaining taps in the
caravan.
3-2
SENATOR CONFIGURATION
PUMP
VALVES
TANK
Fig. 1 Using an external water supply
Fig. 3 Using the onboard tank
PAGEANT CONFIGURATION
Fig. 2 Filling the onboard tank
Fig. 4 Winterising