JVC EXAD KD-AV7000 Instructions Manual page 347

ı
Installing the hideaway unit (under the front seat)
Tapping screws (not supplied)
n
m
Ç
Electrical connections
Before connecting...
• Make sure that the antenna cord from the car is connected to the hideaway unit (see page 2). If the
antenna cord is not long enough, use the extension antenna cord (supplied).
• Check the wiring in the car carefully. Incorrect connection may cause serious damage to the units.
The leads of the power cord and those of the connector from the car body may be different in color.
Main unit
Where-to-connect depends on your dimmer usage.
For details, see page 46 of the Instructions.
4
Orange with white stripe
(ILLUMINATION)
Hideaway unit
To cellular phone system
To parking brake of the car
5
Light green
White with black stripe
White
Left speaker (front)
* 1 Not supplied with this unit.
2
* Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power cannot be turned on.
PRECAUTIONS on power supply and
speaker connections:
• DO NOT connect the speaker leads of the
power cord to the car battery; otherwise, the
units will be seriously damaged.
• BEFORE connecting the speaker leads of the power
cord to the speakers, check the speaker wiring in
your car.
+ + + +
L
L
- -
- -
+ + +
+
R R
-
- -
-
Floor
1
2
Black
Yellow* 2
To a live terminal in the fuse block connecting to the car battery (bypassing the
2
6A
ignition switch) (constant 12 V)
Red
2
Black
15 A fuse
* 2
Yellow
2
Brown
7
Blue
Blue with white stripe
(PARKING BRAKE)
6
Gray
Gray with black stripe
Right speaker (front)
Connecting the parking brake wire
Connect the parking brake wire to the parking brake system built in the car.
Parking brake
+ +
L
-
-
+ +
R
-
-
How to connect the crimp connector
Wire connecting the battery and the parking brake switch.
Attach the parking brake wire (light green) to this point.
• Be sure to use the tapping screws (not supplied) of appropriate length so that they will not
damage any parts of the car.
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the wiring harness to the units.
3
Connect the main unit and the hideaway unit using AV bus cable (supplied).
1
To metallic body or chassis of the car
3
To an accessory terminal in the fuse block
1
1
To metallic body or chassis of the car
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch) (constant 12 V)
3
To automatic antenna if any—250 mA max.
4
To the remote lead of other equipment—200 mA max.
Green with black stripe
Green
Left speaker (rear)
h
Parking brake switch (inside the car)
Contact the metallic part of the crimp
to the wires inside.
3
* 1
Ignition switch
1
*
Fuse block
1
*
Ignition switch
* 1
Fuse block
Purple
Purple with black stripe
Right speaker (rear)
Parking brake wire (light green)
PARKING
BRAKE
To metallic body or chassis
of the car
Pinch the crimp firmly.