JVC EXAD KD-AV7000 Instructions Manual page 265

Connecting the parking brake wire
Connect the parking brake wire to the parking brake system built
in the car.
Parking brake
!"
Parking brake switch (inside the car)
!"#$%&' ()
How to connect the crimp connector
Wire connecting the battery and the parking brake switch.
!"#$%&'()* +,
Attach the parking brake wire (light green) to this point.
!"#$%&'()*+,-./
D Connecting the cradle
By using the cradle (KV-CR100), you can remove the monitor
from the main unit and insert it into the cradle so that the persons
sitting on the rear seat can view the playback picture even while
the driver are driving your car.
• The driver must not put on the headphones while driving. It is
dangerous to shut off the outside sounds while driving.
• Additional monitor (KV-MAV7002) can also be purchased to
used so that you do not need to remove the monitor from the
main unit.
Main unit
AV bus cable supplied for KV-CR100
KV-CR100
AV bus
* 3 When not in use, store the monitor in the supplied soft case for its protection.
!"#$%&'()*+,-./01234567
* 3
* 3
After removing the monitor from the main unit, insert the blind
cover into the main unit to prevent internal dust accumulation.
!"#$%&'()*+,"#-./01234
!"#$%&
!"#$%&'()*+ ),
!"# !$
Contact the metallic part of the crimp to the wires inside.
!"#$%&'()*+,$-./
D
!"#$%KV-CR100
!"#$%&'()*+,-./(0123456
!"#
!"#$%&'() *$%&+,-./012
•
!"#$%
!"#$%&'(KV-MAV7002
•
!"#$%&'()*
!"#"$%&'
KV-CR100
Hold
!"-./
PARKING
h
BRAKE
!
!"#$%&'()*
!"#
Stereo mini plug (∅ 3.5 mm)
5
Parking brake wire (light green)
!"#$%&'()
To metallic body or chassis of the car
!"#$%& '
Pinch the crimp firmly.
D
(KV-CR100)
•
• KV-MAV7002
Removable monitor
or additional monitor KV-MAV7002 *
!"
!" KV-MAV7002 *
KV-MAV7002 *
Headphones (not supplied) *
!"#$%*
KV-CR100
4
* To listen to source sound while in Dual
Mode operations.
See page 33 of the INSTRUCTIONS
(separate volume).
4
*
4
*
33
!"#$%∅ 3.5 mm
∅ 3.5
!"#$%
3
3
3
4
4
* 4
!"#$%&'()*+,-.
!
!"#$%&33 !"#
o