Table of Contents
Advertisement
Important:
Electrostatic discharge (ESD) can damage your system board, processor,
disk drives, add-in boards, and other components. Perform the upgrade
instruction procedures described at an ESD workstation only. If such a
station is not available, you can provide some ESD protection by wearing
an antistatic wrist strap and attaching it to a metal part of the system
chassis. If a wrist strap is unavailable, establish and maintain contact
with the system chassis throughout any procedures requiring ESD pro-
tection.
System Memory
Important:
When the Standby Power LED lit yellow, it indicates that there is power
on the system board. Power-off the PC then unplug the power cord prior
to installing any devices. Failure to do so will cause severe damage to
the motherboard and components.
The system board supports two DDR3 SODIMM sockets.
Note:
The system board supports maximum of 4GB (for LR102-B18D/S) and
2GB (for LR102-B18M) system memory however you can install maxi-
mum of 1GB only per SODIMM socket.
Hardware Installation
DDR3_2
DDR3_1
Standby
Power LED
2
17
Advertisement
Table of Contents
