Super Io Configuration - DFI LR102 SERIES User Manual

3
BIOS Setup

Super IO Configuration

This section is used to configure the I/O functions supported by the onboard
Super I/O chip.
Configure Win627DHG-P Super IO Chipset
Serial Port1 Address
Serial Port2 Address
PWRON After PWR-Fail
Configure Secondary Fintek F81217U Super IO Chipset
Serial Port3 Address
Serial Port3 IRQ
Serial Port4 Address
Serial Port4 IRQ
Serial Port1 Address to Serial Port4 Address
Auto
Automatically selects a base address for the COM port.
3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4
Selects the COM port's base address.
Disabled
Disables the COM port.
PWRON After PWR-Fail
Off
When power returns after an AC power failure, the system's power is off. You
must press the Power button to power-on the system.
On
When power returns after an AC power failure, the system will automatically
power-on.
Former-Sts
When power returns after an AC power failure, the system will return to the
state where you left off before power failure occurs. If the system's power
is off when AC power failure occurs, it will remain off when power returns.
If the system's power is on when AC power failure occurs, the system will
power-on when power returns.
This field is used to select the time interval of the Watchdog timer. If the
system hangs or fails to function, it will reset at the set time interval so that
your system will continue to operate.
66
BIOS SETUP UTILITY
Advanced
[3F8/IRQ4]
[2F8/IRQ3]
[Former-Sts]
[3E8]
[11]
[2E8]
[10]
v02.61 (C)Copyright 1985-2006, American Megatrends, Inc.
Allows BIOS to select
Serial Port 1 Base
Addresses.
Select Screen
← →
Select Item
↑↓
+ -
Change Option
F1 General Help
F10 Save and Exit
ESC Exit