To Reconfigure A Device Manually; Displaying System Fault Information; To Display System Fault Information - Sun Microsystems Netra T2000 Administration Manual

Device Identifiers and Devices (Continued)
TABLE 4-6
Device Identifiers (Continued)
IOBD/PCIEb
TTYA
MB/CMP0/CHchannel-number/Rrank-number/Ddimm-number

To Reconfigure a Device Manually

▼
1. Obtain the ALOM prompt.
See "Switching Between the Consoles" on page
2. At the sc> prompt, type:
sc> enablecomponent asr-key
where asr-key is any device identifier from
Note – The device identifiers are not case-sensitive. You can type them as uppercase
or lowercase characters.
You can use the ALOM enablecomponent command to reconfigure any device that
you previously unconfigured with the disablecomponent command.

Displaying System Fault Information

ALOM software lets you display current valid system faults. The showfaults
command displays the fault ID, the faulted FRU device, and the fault message to
standard output. The showfaults command also displays POST results.

To Display System Fault Information

▼
1. Obtain the ALOM prompt.
See "Switching Between the Consoles" on page
46 Netra T2000 Server Administration Guide • September 2006
Devices (Continued)
PCI-E leaf B (/pci@7c0)
DB9 serial port
DIMMS
6.
.
TABLE 4-6
6.