Module Setup Copying - D&R CinemIX Owner's Manual

MODULE SETUP COPYING

The S3 (Copy) switch allows you to copy a selected module's setup to another
module or to all modules. The following are easy steps describing this
operation.
Step 1: Select a module, press the S3 (Copy) switch and
select another module by the DATA ENTRY (encoder)
control knob.
Step 2: As soon as you hit ENTER all data will be
copied to the selected module (or all) and the data from these modules will be
stored in Cinemix's memory (on board microprocessor).
S4 will also store the copying process.
Note: Press ESC to leave the copy menu.
DYNamics
By depressing the Dyn switch S2 you enter the dynamics menues. It looks like
this
The data entry knob let's you toggle between the channel and Mix part of the
input modules, while the ARM switches let's you choose
the module you want to ad dynamics to.
All data related to the selected module can be changed by
pushing S1 up to S4. Its related LED lites and the encoder
can change dynamics data. The << >> switches rolls through all the parameters
that can be adjusted by the data wheel.
ESC leaves the Dynamics parameter menu and lets you move to another module
by way of the local module's ARM switch or the Data entree wheel.
PROJECT
All settings related to a project are made in "Dynamics" display.
S3 (Proj) selects the project. In the project menu you can select a project
number by depressing the << and >> switches or turning the DATA ENTRY
encoder control.
A maximum of 32 projects can be stored
The S1 (CALL) switch Recalls a project. S4 (save) saves the project.
-ARM Set-
Undo Dyn
-ARM set-
Copy to
-Dynamics-
Dyn ARM
Project
Call
Cinemix manual page: 15
Mod: 1
Copy Erase
Mod: 1
Mod: 2
Mod Mn 1 Chan
Proj Lib
Proj. 32
Save