Special Available Options In Your Airmate-Usb Module; Input Connectors - D&R AIRMATE-USB Manual

FADER
Final control of the channel is the 100mm long throw K-Alps stereo channel fader with integrated fader start
switch. The channel fader sends the amount of signal from the associated channel to the master mix buss. At the
beginning of the fader movement you will feel an internally built in start switch that is activated when you bring up
the fader. This switch activates the start circuitry and controls externally connected devices such as CD players etc
(via the Start connector on the back).

INPUT CONNECTORS

On the back of your AIRMATE-USB modules 5 and 6 you will find the following five connec-
tors.
Two unbalanced line input RCA Cinch connectors (stereo input) for connecting CD
players or any play-back devices such as cart machines, cassette players, or iPods. Any
line level equipment can be connected here. The level can be set using the gain control to
match most source levels.
The left RCA Cinch connector is the left input and the right RCA Cinch connector is the
right input. The shield is to be connected to the ground or case of the RCA Cinch connec-
tor.
The USB connector is wired according to International standards and is a stereo USB1.1
Codec (HID Interface) digital input, as well as an output.
The START switch has two active connections to be wired. The tip and ring are shorted
when the ON switch or fader switch is activated. Once you have done this, you can start a
turntable or other devise with the ON switch via the START connector on the back panel.
The START switches quick start turntables through the remote jack by a continuous con-
tact action at the back of the mixer. If your turntable only needs a pulse to start, ask your
dealer to modify the internal circuitry to change it to a momentary action, so it can be
used as a pulse start switch.
*NEVER CONNECT THE MAINS TO THIS REMOTE-JACK*
Connections on the START connector can only be made with a maximum of 24 Volts by 50
mA.
Please contact your dealer in case of doubt.
The balanced Mic input is on XLR and can provide 48volt phantom powering.

SPECIAL AVAILABLE OPTIONS IN YOUR AIRMATE-USB MODULE

On the input PCB of your AIRMATE-USB module there are several jumpers that can be changed to enable different
configurations of the channel settings. This should be done by a D&R dealer or service center.
The following 8 jumper settings can be changed to adjust the Airmate-USB to fit your needs.
1 J12-13 R.I.A.A. correction amp PCB can be inserted on Jumper J12 and J13.
2 J3 Low cut filter on Mic input only By shorting all 4 pins on Jumper J3.
3 J1 48 volt phantom power via Jumper J15.
4 J6/16 Stereo Aux send pre or post selectable via Jumper J6/16 (post is default).
5 J7 Clean-Feed (CLN-FEED) jumper (J7) to select whether the audio stereo signal
(summed to mono) is send to the clean-feed bus that is available in the master section for
external Hybrids.
6 J17 Pulse/continuous Jumper J17 to change the start pulse from latching (continuously) to pulse.
7 J5 Mic gain ( Jumper J5) can be set to amplify an extra 20dB or 40dB.
8 J28-32 USB output selection to select pre-or post master fader.