Program Loading The Ice Terminal - Infinity ICE4000 Hardware And Installation Manual

Program Loading the ICE Terminal

A program load is required when no software is currently in the terminal. Depending on the
software application, an average program load takes approximately 40 minutes to complete. The
initialization process loads the merchant-specific information in a terminal.
In order to process debit transactions, you must authenticate or MAC (Message Authentication
Code) the software in the ICE 4000 terminal. Please refer to the PIN Pad Loader Operator ' s
Manual for further details.
Step-by-Step
To load a program into the ICE terminal:
Step Action
The boot menu appears.
1 Touch Program Load on the terminal display.
Touch Yes on the terminal display, or touch Enter on the
2
terminal. The terminal checks the phone line for a proper
connection.
The terminal detects a proper phone line connection and is
waiting to detect a dial tone.
The terminal detects a dial and is waiting to dial out.
The terminal has dialed out and is waiting for an answer from
the host.
The terminal has made a connection and is communicating
with the host.
The terminal is downloading the software application from the
host. The approximate time is 25 to 45 minutes.
The terminal has successfully downloaded the software
application from the host.
940265-001, rev. D Hypercom Corporation
Installation Procedures
Terminal response
PLEASE INITIALIZE
OR CALL HELP-FE
Restart
Merchant Program
Program Load
Clear Page Memory
Maintenance Funcs
Fast Load
PROGRAM LOAD
CORRECT?
NO YES
PROGRAM LOAD
CHECKING LINE
PROGRAM LOAD
WAITING FOR DIAL TONE
PROGRAM LOAD
DIALING NOW
PROGRAM LOAD
WAITING FOR ANSWER
PROGRAM LOAD
TRAINING MODEM
PROGRAM LOAD
LOADING MEM 01 X X X X
PROG. LOAD
PROG. LOAD GOOD
2-11