Powering Up The Terminal - Infinity ICE4000 Hardware And Installation Manual

Chapter 2

Powering up the Terminal

The ICE 4000 terminal operates using a +12/+15 Vdc power cable in conjunction with a 110-Volt
grounded power receptacle.
Step-by-Step
To power up the ICE 4000 terminal:
1. Connect the +12/+15 VDC power cable from the AC adaptor to the terminal power socket
labeled PWR on the bottom of the ICE 4000 terminal.
2. Plug the adaptor into a 110-Volt (or 220-Volt in some countries) grounded power receptacle.
Be sure the connector is firmly seated. Press and hold the green power switch, which is
located on the right side of the terminal. When the power is connected successfully, the
terminal beeps twice and then performs a self-test and diagnostic routine.
W
ARNING
n
Do not use an adaptor, a power extender adaptor, a power extender cable, or an AC outlet that does
not have a ground connection.
n
Do not disassemble the AC adaptor. Only qualified service personnel should service the adaptor.
n
The AC adaptor was designed for indoor use only. Do not expose to rain or snow.
n
Do not immerse in fluid.
n
The reliability of electronic equipment is significantly reduces when it is powered from an
underground outlet. A low-power AC adaptor connects power to the terminal. Connect only one
terminal to the AC adaptor.
N :
To fully charge the battery for mobile use, plug in the +12/+15 VDC power cable and turn the
OTE
terminal on. Leave the terminal powered up for six hours before using.
2-2 ICE 4000 Hardware and Installation Manual 940265-001, rev. D