User Functions; User Access - Honeywell LYNX Touch L7000 Series User Manual

General Information
For additional security you (the Master User Code) can assign secondary user codes to individual users
enabling them to perform specific system functions. These secondary users are identified by "User Numbers"
when their codes are assigned. You can assign up to
who can assign codes to secondary users.
All codes can be used interchangeably when performing system functions (a system armed with one user's code
can be disarmed by another user's code), with the exception of the
 Guest Code: This code can be used to arm the system, but cannot disarm the system unless the system
was armed with this code. This code is typically assigned to someone (such as a Guest) who needs to
arm/disarm the system only at certain times.
 Duress Code: This feature is intended for use when you are forced to disarm or arm the system under
threat. When used, the system will act normally, but can silently notify the alarm monitoring company of
your situation, if that service has been provided. The Duress Code is useful only when the system is
connected to an alarm monitoring company.
IMPORTANT: Temporary users of the system (e.g., Guests, cleaning staff) should not be shown how to use any
system function they do not need to know, such as bypassing protection zones for example.
Adding a User
Ready To Arm
Arm Away Arm Stay
Delay 10:18 AM June 8, 2010
Ready To Arm
Program the system
Enter Code:
Cancel
Ready To Arm
Users Events
Date Time Reminders
Tools
Settings
Back
5200-100-033-V0
1 2 3
4 6
5
7 9
8
Clear 0
5200-100-035-V0
Test Keypad
Slide Show WiFi Config
Back
5200-100-036-V0
46 user codes. Note that the Master User is the only one
Guest
1. With the system in the disarmed state, select the "Tools" icon
from the second page of the Security Screen. The system
displays the Keypad screen.
2. Enter your 4-digit Master User Code. The system displays the
Master User programming screen.
3. Select the "Users" icon. The system displays the Master User
screen.
– 33 –

USER FUNCTIONS

User Access

Code described below.