Honeywell LYNX Touch L7000 Series User Manual page 19

SECURING THE PREMISES
Arming the System
Arming In Away Mode
Use this mode when no one will be staying on the premises. Close all protected perimeter windows and doors
before arming. The green Ready indicator on the control should be lit if the system is ready to be armed. When
armed in AWAY mode, the system will sound an alarm if a protected door or window is opened, or if any
movement is detected inside the premises, when infrared detection devices are used. You may leave through a
designated entrance door during the exit delay period without causing an alarm. You may also re-enter through
the entrance door, but you must disarm the system within the entry delay period or an alarm will occur. If
Quick Arm was programmed by the installer, you do not need to enter the security code to arm the system. The
security code must always be used to disarm the system, however. If your
programmed for burglary protection, the system can be armed while the Garage Door is opened. A "Fault" will
be displayed by the control but will clear once the door has been closed. The Garage Door zone will be
subsequently be monitored by the system.
the Exit Time expires and no exit has been made. Refer to Auto Stay Arming Feature for additional information.
The Guest Code and Installer Code cannot disarm the system unless it was used to arm the system. In addition,
if the system is armed by pressing via Quick-Arming, neither the
system.
Ready To Arm
Arm Away Arm Stay
Delay
10:18 AM June 8, 2010
Ready To Arm
Arm the system in Away
mode
Enter Code:
Silent Exit
Cancel Quick Arm
Armed Away - Exit Now
Exit now
28 seconds
Disarm Restart
10:18 AM June 8, 2010
If Auto Stay Arming is enabled, the system will Arm in STAY mode
Zones System
Message
More
7000-100-020-V0
1 2 3
4 5 6
7 8 9
Clear 0
5200-100-018-V0
Zones
System
Message
More
7000-100-023-V0
Guest
1. Select the Arm Away icon, the system beeps once and
displays a keypad.
2. Enter a valid User Code. OR
If Quick Arm has been enabled, select the "Quick Arm"
icon.
The system beeps two times and announces "Armed Away
Exit Now. The exit delay screen is displayed. If
programmed the display counts down the time remaining in
the exit delay in seconds.
Note: If a valid user code is not entered or the Confirm icon has not
been selected within 10 seconds, the system will return to the
"home" screen and it will not be armed.
3. If "Exit Warning" has been enabled, the system will
continue to beep throughout the exit delay. Rapid beeps
will sound for the final 10 seconds of the delay period.
– 20 –
system's Garage Door Zone has been
Code nor Installer Code can disarm the
if