Table of Contents
Advertisement
The KEYMAP Page
Press the KEYMAP soft button to call up the KEYMAP page. The parameters on this page affect
sample root selection, i.e., which samples are played on which keys.
Parameter
Keymap
Transpose
Key Tracking
Velocity Tracking
Alt Method
Stereo
Timbre Shift
Playback Mode
Alt Control
Keymap
Assign a keymap from ROM to the current layer. Keymaps are collections of samples assigned
to note and velocity ranges. With the Keymap parameter selected, press the Edit button to enter
the Keymap editor (see The Keymap Editor on page 14‐1 for details.)
Transpose (Xpose)
Transpose the current keymap up as much as 127 semitones (ten octaves and a perfect fifth) or
down as much as 128 semitones (ten octaves and a minor sixth).
Key Tracking (KeyTrk)
This is one of the six common DSP control parameters. On the KEYMAP page, key tracking
affects the interval between notes. The default value of 100 cents (a cent is a hundredth of a
semitone) gives you the normal semitone interval between each note. Higher values increase the
interval; lower values decrease it. Negative values will cause the pitch to decrease as you play
higher notes.
When you make changes to this parameter, you'll need to keep in mind that KeyTrk on the
KEYMAP page works in conjunction with KeyTrk on the PITCH page. Therefore, you'll need to
check the KeyTrk value on both pages to see how key tracking works within a program. Unless
you're looking for nonstandard note intervals, the values of the KeyTrk parameters on the
PITCH and KEYMAP pages should add up to 100 cents.
Range of Values
Keymap List
-128 to 127 semitones
± 2400 cents per key
± 7200 cents
Switched, Continuous
Off, On
± 60 semitones
Norm, Rvrs, Bidirectional, Noise
Control Source List
Program Mode
The KEYMAP Page
Default
1 Piano f Left
0
100
0
Switched
Off
0
Normal
Off
6-19
Advertisement
Table of Contents
