Kurzweil PC3K Series Musician's Manual page 243

MIDI Mode
The RECEIVE Page
Using External CCs In Setup Mode, Local Keyboard Channel Off, Input Channel None
To control a program parameter via external MIDI CC in Setup Mode, the parameter must first
have a source assigned within the Program Editor, as described in the Assigning A CC Control
Source section above. To control an assigned parameter, send the correct CC number to the
channel for the Setup zone which contains the program.
Using External CCs In Setup Mode, Local Keyboard Channel On, Input Channel None
To control a program parameter via external MIDI CC in Setup Mode, the parameter must first
have a source assigned within the Program Editor, as described in the Assigning A CC Control
Source section above. To control an assigned parameter with a Local Keyboard Channel set,
send the correct CC number to the channel set for Local Keyboard Channel. (If the CC # is listed
in the "External MIDI CC Remapping" table below, the CC will be remapped to the destination
set for that physical controller in the Setup Editor. In this case, you must use the Setup Editor to
assign that physical controller's destination to the original CC number that you sent. For
destinations that show a name, a corresponding MIDI CC number can be found by finding the
name in The Controller Destination List (see page 7‐22.))
Within the Setup Editor, you can also set a PC3K physical controller to send a CC number to a
program on a zone. If this is done with a Local Keyboard Channel set, you will also be able to
control a parameter by sending the default CC number for that physical controller to the
channel set for Local Keyboard Channel. The table below lists the default CC number used to
control the assignments of PC3K physical controllers while in Setup Mode.
Also, for each physical controller, if a CC# is listed in the "Additional MIDI CC# Which Always
Controls The Parameter Assigned To Each PC3K Physical Controller In Setup Mode" column,
then that physical controller's assignment can always be controlled by the CC# listed in that
column. For physical controllers where this is the case, the physical controller's assignment will
respond to the CC# listed in the "Additional MIDI CC# Which Always Controls The Parameter
Assigned To Each PC3K Physical Controller In Setup Mode" column, as well as the physical
controller's default CC number.
Using External CCs In Setup Mode, Local Keyboard Channel None, Input Channel On
To control a program parameter via external MIDI CC in Setup Mode, the parameter must first
have a source assigned within the Program Editor, as described in the Assigning A CC Control
Source section above. To use an InputChannel (see page 7‐8,) Local Keyboard Channel must be
set to None. To control an assigned parameter for a program on a zone that has an
InputChannel set, send the correct CC number to the channel set for that zone's InputChannel.
(If the CC # is listed in the "External MIDI CC Remapping" table below, the CC will be
remapped to the destination set for that physical controller in the Setup Editor. In this case, you
must use the Setup Editor to assign that physical controller's destination to the original CC
number that you sent. For destinations that show a name, a corresponding MIDI CC number
can be found by finding the name in The Controller Destination List (see page 7‐22.))
Within the Setup Editor, you can also set a PC3K physical controller to send a CC number to a
program on a zone. If this is done with a InputChannel set, you will also be able to control a
parameter by sending the default CC number for that physical controller to the channel set for
InputChannel. The table below lists the default CC number used to control the assignments of
PC3K physical controllers while in Setup Mode.
Also, for each physical controller, if a CC# is listed in the "Additional MIDI CC# Which Always
Controls The Parameter Assigned To Each PC3K Physical Controller In Setup Mode" column,
then that physical controller's assignment can always be controlled by the CC# listed in that
column. For physical controllers where this is the case, the physical controller's assignment will
respond to the CC# listed in the "Additional MIDI CC# Which Always Controls The Parameter
Assigned To Each PC3K Physical Controller In Setup Mode" column, as well as the physical
controller's default CC number.
10-11