Table of Contents
Advertisement
MIDI Mode
The RECEIVE Page
Basic Channel
The basic channel determines which channel will always be available to receive MIDI
information. Depending on the MIDI receive mode (below), the Basic channel may be the only
receiving channel, or one of several.
MIDI Receive Mode (MIDI Mode)
The MIDI Mode parameter determines the MIDI receiving capabilities of the PC3K. When set to
Omni, the PC3K responds to incoming MIDI events on all MIDI channels, and plays them on
the current channel. This is normally used for diagnostic purposes only.
At a setting of Poly, the PC3K responds only to events that are sent on the same channel as the
PC3K's current MIDI channel (the one displayed on the top line of the Program mode page). In
Poly mode, the currently selected channel is always the basic channel, so if you change channels,
the basic channel changes accordingly.
With a value of Multi (the default), the PC3K responds to events on all active channels. This is
the mode you'll use when you're driving the PC3K with a sequencer, since you can play a
different program on each channel. At this setting, you can turn individual channels on and off
(on the CHANNELS page, described later in this chapter).
All Notes Off
If this parameter's value is set to Normal, the PC3K responds to All Notes Off messages received
over MIDI. Ignore causes these messages to be ignored. If you're using a Roland product as a
MIDI controller for your PC3K, you'll want to set the value of this parameter to Ignore. This is
because some older Roland products occasionally send an All Notes Off message when no keys
are held down—even if you're sustaining notes with a pedal. You might find all your sustains
missing from your sequence, for example, if you're driving your PC3K from one of Roland's
hardware sequencers. Setting this parameter to Ignore takes care of this problem.
Regardless of the setting for this parameter, the PC3K always responds to its own Panic button
by shutting off all active notes and controllers.
Program Change Mode (PrgChgMode)
This determines how the PC3K responds to program change commands received via MIDI. See
Program Change Formats on page 10‐15 for an explanation of the various values available for this
parameter.
10-6
Advertisement
Table of Contents
