Basic Settings; Car Pool Lanes - Mercedes-Benz COMAND Operating Instructions Manual

Basic settings

56
Basic settings
Setting route type and route options
Route settings menu (start of menu)
To select the route type
:
Setting the number of persons in the
;
vehicle for the use of carpool lanes
To set route options
=
Select Navi Navi in the main function bar by
X
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
Select Route Settings Route Settings
X
confirm.
The route settings menu appears.
Select a route type and press W to confirm.
X
A filled circle indicates the current setting.
Select the route option(s) and press W to
X
confirm.
The route options are switched on O or off
ª, depending on the previous status.
i
If you change the route type and/or the
route options while route guidance is
active, COMAND will calculate a new route.
If you change the route type and/or the
route options while route guidance is
inactive, COMAND uses the new setting for
the next route guidance.
Route guidance active: a destination has
been entered and the route has been
calculated.
Route guidance inactive: no destination
has been entered yet and no route has been
calculated yet.
i
RDS-TMC is not available in all countries.
You can select the following route types:
Fast Route Fast
R
with the shortest (minimized) journey time.
Dynamic Traffic Dynamic Traffic Route
R
type as
takes into account any relevant traffic
reports received during route guidance.
The navigation system can help you avoid
a traffic jam, for example, by recalculating
the route.
Dynamic TRF. Route After Dynamic TRF. Route After Request
R
same route type as
Route. After recalculating the route, Route
COMAND asks you whether you want to
adopt the new route or whether you want
to continue along the original route.
Eco Eco Route
R
the
attempt to minimize the journey distance
at the expense of a slightly increased
journey time.
and press W to
Short Short Route
R
with the shortest possible (minimized)
route distance.
i
The route calculated may, for example,
include ferry connections, even if the
Avoid Ferries Avoid Ferries
on.
In some cases, COMAND may not be able
to take all the selected route options into
account, e.g. when calculating particularly
long routes.
To exit the menu: slide XVY the COMAND
X
controller.
To set the number of persons in the
vehicle for the use of carpool lanes
For route calculation, you can take HOV or
carpool lanes into account.
If you use HOV or carpool lanes, please
observe the applicable laws as well as the
local and time limitation conditions.
Route: COMAND calculates a route
Route: same route
Fast Route Fast Route. In addition, COMAND
Dynamic Traffic Dynamic Traffic
Route: the Eco Route Eco Route is a variant of
Fast Route Fast Route route type. COMAND will
Route: COMAND calculates a route
route option is switched
Request: