Entering An Intermediate Stop - Mercedes-Benz COMAND Operating Instructions Manual

Destination input
66
Entering a destination using geo-
coordinates
To switch to navigation mode: press the
X
Ø function button.
To show the menu: press W the COMAND
X
controller.
Select Dest. Dest. in the navigation system
X
menu bar by turning cVd the COMAND
controller and pressing W to confirm.
Select Using Geo-Coordinates Using Geo-Coordinates
X
press W to confirm.
An entry menu appears.
You can now enter the latitude and longitude
coordinates.
To change a value: turn cVd the
X
COMAND controller.
To move the mark within the line: slide
X
XVY the COMAND controller.
To move the mark between the lines:
X
slide ZVÆ the COMAND controller.
To confirm the value: press W the
X
COMAND controller.
i
If the selected position is outside the
digital map, COMAND uses the nearest
digitized road for route calculation. You will
see the The coordinates The coordinates are
map map message. If the selected position is
located over a body of water, you will see
the message: The destination is in The destination is in
a body of water. Please select a body of water. Please select
another destination. another destination.
Intermediate stop

Entering an intermediate stop

To switch to navigation mode: press the
X
Ø function button.
To show the menu: press W the COMAND
X
controller.
Select
X
menu bar by turning cVd the COMAND
controller and pressing W to confirm.
and
Intermediate stop categories
Option 1: the route does not have an
intermediate stop.
Select
X
Select a category; see option 2.
X
Option 2: the route already has an
intermediate stop.
Select
X
confirm.
are off off the the
Dest. Dest. in the navigation system
Stopover Stopover and press W to confirm.
Change Stopover Change Stopover and press W to