Entering - Mercedes-Benz COMAND Operating Instructions Manual

Example: search results for the chosen category
COFFEE SHOP
Highlighted stopover, current distance
:
from vehicle position and name of
stopover
To select a category: select a category by
X
turning cVd the COMAND controller and
press W to confirm.
COMAND first searches in the selected
category for destinations along the route.
If there are no destinations available there,
COMAND searches for destinations within
a radius of 60 miles(100 km) of the vehicle
position.
If COMAND finds destinations, a list
appears on the right-hand side of the
display.
The stopovers along the route are displayed
at the top of the list, sorted by increasing
distance from the vehicle's current position.
Below this, you will see the stopovers that
COMAND finds in the vicinity of the vehicle's
current position.
i
For stopovers that are not located along
the calculated route, the linear distance is
shown.
Select an intermediate stop by turning
X
cVd the COMAND controller and press
W to confirm.
The address entry menu appears, showing
the destination address.
To start route calculation: select
X
and press W to confirm.
If COMAND does not find any destinations,
you will see a message to this effect.
Confirm OK OK by pressing W.
X
Select a different category.
X
Deleting a stopover
If a stopover has already been entered, you
can delete it.
To switch to navigation mode: press the
X
Ø function button.
To show the menu: press W the COMAND
X
controller.
Select Dest. Dest.
X
menu bar by turning cVd the COMAND
controller and pressing W to confirm.
Select Stopover Stopover
X
Select Delete Stopover Delete Stopover
X
confirm.
COMAND deletes the intermediate stop
and recalculates the route to the main
destination.
Entering waypoints
Introduction
You can map the route yourself by entering
up to two waypoints. The sequence of the
waypoints can be changed at any time.
i
An intermediate stop is always between
the current position of the vehicle and the
first waypoint.
Creating waypoints
To switch to navigation mode: press the
X
Ø function button.
To show the menu: press W the COMAND
X
controller.
Start Start
Select Dest. Dest.
X
menu bar by turning cVd the COMAND
controller and pressing W to confirm.
Destination input
in the navigation system
and press W to confirm.
and press W to
in the navigation system
67
Z