Notes - Mercedes-Benz COMAND Operating Instructions Manual

Map operation and map setting
102
Storing the crosshair position in the
list of previous destinations
A crosshair appears on the map if you have
moved the map manually (
can store the crosshair position as a
destination in the list of previous
destinations.
To show the menu: press W the COMAND
X
controller.
Select Position Position
X
menu bar by turning cVd the COMAND
controller and press W to confirm.
Select Save Crosshair Position Save Crosshair Position
X
press W to confirm.
Deleting one of the previous
destinations
To switch on navigation mode: press the
X
Ø function button.
To show the menu: press W the COMAND
X
controller.
Select Dest. Dest. in the navigation system
X
menu bar by turning cVd the COMAND
controller and pressing W to confirm.
Select From Last Destinations From Last Destinations
X
press W to confirm.
The list of last destinations appears.
Select the desired destination and press
X
W to confirm.
The destination address appears.
Select Delete Delete and press W to confirm.
X
A prompt appears asking whether the entry
should be deleted.
Select Yes Yes or No No
X
If you select Yes, the entry is deleted. Yes
If you select No, the process will be No
canceled.
page 103). You
Y
in the navigation system
and
and
and press W to confirm.
Map operation and map setting
General notes
Company logos displayed on the map are
trademarks of the respective companies and
used solely for the purpose of indicating the
locations of these companies. The use of such
logos on the map does not indicate approval
of, support of or advertising by these
companies for the navigation system itself.
Setting the map scale
Set map scale as a number with unit
:
Currently set map scale as indicated by
;
the needle on the scale bar
New map scale
=
Scale bar
?
Unit of measurement : in the COMAND
display depends on the selection made for the
instrument cluster, see the separate vehicle
Operator's Manual.
To hide the menu: slide ZV the COMAND
X
controller and, when the
menu item is shown, press W.
To call up the scale bar: as soon as you
X
turn cVd the COMAND controller, scale
bar = appears.
Turn cVd until the desired scale is set.
X
Full Screen Full Screen