Table of Contents
Advertisement
Read the instructions below carefully and refer to the
diagrams. If logs are broken do not use the unit until
they are replaced. Broken logs can interfere with the
pilot operation.
Log Kit # 360-930 contains the following pieces:
a) 326
Front Right Log
b) 327
Front Left Log
c) 328
Middle Right Log
d) 329
Middle Left Log
e)
Embers (902-154)
f)
Platinum Embers (946-669) -
aged manual
Please note that there are 2 of each log.
This log set is mirrored front and back.
327
329
The 3-digit numbers (ie. 327) are molded into the rear of each log.
1) Carefully remove the logs from the box and unwrap
them. The logs are fragile, handle with care - do not
force into position.
2) Place embers on the burner as shown below.
Separate platinum embers and place on the burner
over top of and around embers. Platinum embers can
cover burner ports. Avoid stacking platinum embers.
IMPORTANT
When placing Embers, do not block burner ports
as this can cause an incorrect fl ame pattern,
carbon deposits and delayed ignition.
Regency PG121/PG131 Zero Clearance Room Sealed Gas Fireplace
LOG SET INSTALLATION
3) Place Log 326 on the front right side of the burner.
Ensure that the notches on the far right side of the log
fi t into the grate posts. Push back side of the left end
of the log up against the tab on the burner.
supplied with pack-
326
Repeat step 3 on the opposite side of the burner.
328
4) Place Log 327 on the front left side of the burner. Po-
sition the right end of the log in between the two tabs
and the left end of the log into the grate post.
INSTALLATION
326
Push back side of the left end of the log up
against the tab on the burner.
326
327
Grate Post
326
Tab on Burner
25
Advertisement
Table of Contents
