GENERATOR AND AUTOLUBE PUMP
LS
2
2
1
EAS00354
INSTALLING THE GENERATOR
1. Install:
• gasket 1
• woodruff key
• generator rotor 2
• washer
1
• generator rotor nut
NOTE:
@
• Clean the tapered portion of the crankshaft
and the generator rotor hub.
• When installing the generator rotor, make
sure the woodruff key is properly seated in
the keyway of the crankshaft.
• Do not allow the rotor holding tool to touch
the projection on the generator rotor.
2. Tighten:
• generator rotor nut 1
NOTE:
@
• While holding the generator rotor 2 with the
rotor holding tool 3, tighten the generator
rotor nut 1.
3
• Do not allow the rotor holding tool to touch
the projection on the generator rotor.
5 - 36
ENG
New
38 Nm (3.8 m · kg, 27 ft · lb)
Rotor holding tool
YU-01235
5