Removing The Generator; Checking The Autolube Pump; Installing The Autolube Pump - Yamaha YJ50RN Service Manual

GENERATOR AND AUTOLUBE PUMP
2
1
1
2
2
1
EAS00346

REMOVING THE GENERATOR

1. Remove:
• generator rotor nut 1
• washer
NOTE:
@
While holding the generator rotor 2 with the
rotor holding tool 3, loosen the generator rotor
3
nut.
Rotor holding tool
2. Remove:
• generator rotor 1
(with the flywheel puller set 2)
• woodruff key
Flywheel puller set

CHECKING THE AUTOLUBE PUMP

1. Check:
• oil hose 1
Obstruction → Blow out with compressed
air.
2. Check:
• autolube pump 2
• pump drive gear 3
Damage → Replace.

INSTALLING THE AUTOLUBE PUMP

1. Install:
• autolube pump 1
• pump drive gear 2
CAUTION:
Push the autolube pump in until it contacts
the right crankcase a, and then tighten the
pump bolt to the specified torque.
5 - 35
ENG
YU-01235
YU-90105