Digital Input Signal Formats - Onkyo HT-S780 Instruction Manual

Advanced Setup

Digital Input Signal Formats

The following table shows the display indicators for each
supported digital signal format.
Format
Dolby Digital
DTS
PCM
Normally, the AV receiver detects the signal format auto-
matically. However, if you experience either of the fol-
lowing issues when playing PCM or DTS material, you
can manually set the signal format to PCM or DTS:
• If the beginnings of tracks from a PCM source are cut
off, try setting the format to PCM.
• If noise is produced when fast forwarding or reversing
a DTS CD, try setting the format to DTS.
STANDBY/ON
STANDBY
A SPEAKERS B
TONE +
PHONES
PURE AUDIO MULTl CH DVD
1
Press and hold the AV receiver's [DIGITAL
INPUT] button for about 3 seconds.
2
While "Auto" is displayed (about 3 sec-
onds), press the [DIGITAL INPUT] button
again to select: PCM, DTS, or Auto.
DTS or PCM: The DTS or PCM indicator,
depending on which format you have set, flashes,
and only signals in that format are output. Digital
signals in other formats are ignored.
Auto (default): The format is detected automati-
cally. If no digital input signal is present, the cor-
responding analog input is used instead.
50
Display
PCM
TUNING / PRESET
ENTER
RETURN SETUP
STEREO LISTENING MODE DISPLAY DIGITAL INPUT RT/PTY/TP MEMORY TUNING MODE
CLEAR
VIDEO
VIDEO 1 VIDEO 2 VIDEO 3 TAPE TUNER CD
VCR
DIGITAL INPUT
MASTER VOLUME
VIDEO 3 INPUT
L AUDIO R