Digital Input Signal Formats - Onkyo HT-S580 Instruction Manual

Advanced Setup—Continued
4
Use the Left and Right [
buttons to adjust the speaker
level, and use the Down [
ton to select the next speaker.
The level can be adjusted from –12 to
+12 dB in 1 dB steps (–15 to +12 dB
for the subwoofer).
5
Repeat step 4 so that the level of
the test tone from each speaker
is the same.
Speakers that you set to No or None in
the Speaker Configuration (page 34) do
not output the test tone.
6
Press the [SETUP] button.
Setup closes.
Don't forget to turn down the volume if
you turned it up while setting the levels.
Note:
• A quicker way to adjust the speaker levels is to press
the remote controller's [TEST TONE] button to output
the test tone, use the [LEVEL–] and [LEVEL+] but-
tons to adjust the levels, and use the [CH SEL] button
to select the speakers.
• If the multichannel input is selected (page 37), in step
2, the "3. MultiLevel" menu appears instead of the
"3. Level Cal" menu, and you can adjust the level of
each channel of the multichannel input regardless of
the Speaker Configuration settings.
52

Digital Input Signal Formats

]/[ ]
The following table shows the display indicators for each
] but-
supported digital signal format.
Format
Dolby Digital
DTS
PCM
Normally, the AV receiver detects the signal format auto-
matically. However, if you experience either of the fol-
lowing issues when playing PCM or DTS material, you
can manually set the signal format to PCM or DTS:
• If the beginnings of tracks from a PCM source are cut
off, try setting the format to PCM.
• If noise is produced when fast forwarding or reversing
a DTS CD, try setting the format to DTS.
STANDBY/ON
STANDBY
A SPEAKERS B
PHONES
1
Press and hold the AV receiver's [DIGITAL
INPUT] button for about 3 seconds.
2
While "Auto" is displayed (about 3 sec-
onds), press the [DIGITAL INPUT] button
again to select: PCM, DTS, or Auto.
DTS or PCM: The DTS or PCM indicator,
depending on which format you have set, flashes,
and only signals in that format are output. Digital
signals in other formats are ignored.
Auto (default): The format is detected automati-
cally. If no digital input signal is present, the cor-
responding analog input is used instead.
Display
PCM
TUNING / PRESET
ENTER
RETURN SETUP
TONE + STEREO LISTENING MODE DISPLAY DIGITAL INPUT RT/PTY/TP MEMORY TUNING MODE
CLEAR
MULTl CH DVD VIDEO 1/VCR VIDEO 2 VIDEO 3 TAPE TUNER CD
DIGITAL INPUT
MASTER VOLUME