Controlling Other Components; Entering Remote Control Codes - Onkyo HT-S780 Instruction Manual

Controlling Other Components

You can use the AV receiver's remote controller
(RC-608M) to control your other components, including
those made by other manufacturers. This chapter
explains how to enter the necessary remote control code
for the component that you want to control (e.g., DVD
player, TV, or VCR).

Entering Remote Control Codes

Entering a remote control code for each REMOTE
MODE button allows you to control your other compo-
nents with the remote controller. You'll need to perform
this procedure for each component that you want to con-
trol.
RECEIVER
Number
buttons
TOP MENU
DISPLAY
1
Look up the remote control code
for the component in the appro-
priate category.
See the separate Remote Control
Codes.
52
ON STANDBY
REMOTE MODE
RECEIVER DVD
REMOTE
TAPE/AMP
INPUT SELECTOR M D MODE
CD
1 2 3
CDR
V 1 V 2 V 3
T V
4 5 6
MULTI CH DVD
7 8 9 VCR
TAPE TUNER CD
+ 10 0
CLR SAT
10 11 12
CABLE
--/--- DIMMER SLEEP
CH
T V VOL VOL
DISC
INPUT
GUIDE PREVIOUS
MENU
SP A / B MUTING
ENTER
RETURN SETUP
LISTENING MODE
STEREO SURROUND
AUDIO SUBTITLE RANDOM REPEAT
LEVEL - LEVEL +
TEST TONE CH SEL
PLAY MODE HDD DVD
L NIGHT
DISPLAY OR-EQ L NIGHT CINE FLTR
RC - 608 M
2 While holding down the REMOTE
MODE button that you want to
set, press the [DISPLAY] button
for 3 seconds.
The REMOTE MODE button lights up.
3
Within 30 seconds, use the num-
ber buttons to enter the 4-digit
remote control code.
The REMOTE MODE button flashes
twice.
4 Press the REMOTE MODE button
again to select the remote con-
troller mode, point the remote
controller at the component, and
check the operation.
If the remote controller works OK, the
code has been entered correctly. If not,
try again or try another code.
Notes:
• A remote control code cannot be entered for the
[RECEIVER] button.
• There are the only codes available at the time that this
instruction manual was printed.
• If the codes don't work, try using other manufacture's
codes to see if it will help you preprogram your remote
controller.