Digital Input Signal Formats; Correcting Sound And Picture Sync - Onkyo HT-SR600 Instruction Manual

Advanced Setup—Continued

Digital Input Signal Formats

The following table shows the display indicators for each
supported digital signal format.
Format
Dolby Digital
DTS
PCM
Normally, the AV receiver detects the signal format auto-
matically. However, if you experience either of the fol-
lowing issues when playing PCM or DTS material, you
can manually set the signal format to PCM or DTS:
• If the beginnings of tracks from a PCM source are cut
off, try setting the format to PCM.
• If noise is produced when fast forwarding or reversing
a DTS CD, try setting the format to DTS.
STANDBY/ON
STANDBY
A SPEAKERS B TONE +
PHONES
MULTl CH DVD VIDEO 1/VCR
1 Press and hold the AV receiver's [DIGITAL
INPUT] button for about 3 seconds.
2
While "Auto" is displayed (about 3 sec-
onds), press the [DIGITAL INPUT] button
again to select: PCM, DTS, or Auto.
DTS or PCM: The DTS or PCM indicator,
depending on which format you have set, flashes,
and only signals in that format are output. Digital
signals in other formats are ignored.
Auto (default): The format is detected automati-
cally. If no digital input signal is present, the cor-
responding analog input is used instead.
54
Display
PCM
TUNING / PRESET
MASTER VOLUME
ENTER
RETURN SETUP
STEREO LISTENING MODE DISPLAY DIGITAL INPUT RT/PTY/TP MEMORY TUNING MODE
CLEAR
VIDEO 2 VIDEO 3 TAPE TUNER CD
DIGITAL INPUT

Correcting Sound and Picture Sync

When using progressive scanning on your DVD player,
you may find that the picture and sound are out of sync.
With this setting, you can correct this by delaying the
audio signals. You can set it to 0, 20, or 40 milliseconds.
ON/STANDBY
INPUT SELECTOR
INPUT 1 2
V 1 V 2
SELECTOR
4 5
MULTI CH
7 8
TAPE TUNER
+ 10 0
--/--- DIMMER
TOP MENU
SP A / B
PLAYLIST
RETURN
1 Press the [RECEIVER] REMOTE
MODE button.
RECEIVER
2
Press and hold, for more than 4
seconds, the input selector but-
ton for the input source that you
V 1 V 2 V 3
want to correct.
DVD This can be the [DVD], [VIDEO 1],
[VIDEO 2], or [VIDEO 3] input
source.
3
Use the Left and Right [
buttons to set the delay to 0, 20,
or 40 milliseconds.
The previous display reappears if you
don't do anything for 5 minutes.
Note:
• This setting is not available when the Direct listening
mode is used with an analog input signal.
REMOTE MODE
RECEIVER
RECEIVER DVD
TAPE
C D
3
V 3
MD
6
DVD
CDR
9
C D
CLR HDD
SLEEP
CH
VOL
DISC
ALBUM
MENU
MUTING
ENTER
PLAYLIST
SETUP
]/[ ]