KTM 250 SX-F 2005 Repair Manual page 75

1
2
6
3
Mounting the oil pumps
– Mount the oil pump shaft with the pressure pump rotors and the
needle roller as illustrated. The marks
opposite the needle roller.
– Slide the preassembled oil pump shaft into the right engine case
half. The marks should no longer be visible.
– Fill the oil pump with engine oil.
– Mount the pressure pump cover. Apply Loctite 222 to the screws
and tighten to 6 Nm.
– Insert the needle roller
2
pump gear .
3
– Mount the stop disk
4
shaft on the other side.
9
5
4
3
2
– Slide on the thrust washer
thrust washer and the lock ring
8
action.
on both rotors must be
1
in the oil pump shaft and mount the oil
and lock washer , holding the oil pump
5
8 7
6
and oil pump idler
6
. Check the wheels for easy
9
6-4
, mount the
7