1 2
1
3
5
– Remove screws
NOTE: the throttle sensor should only be dismounted if defective. If
the screws
– Remove screw
carburetor.
– Remove the 2 screws and take the intake trumpet together with the
O-ring
4
– Unscrew the idle-air jet
– Thoroughly clean all jets and other parts and blow compressed air
through them.
– Clean the carburetor housing and blow compressed air through all
the ducts in the carburetor.
6
– Check all gaskets for damage and, if necessary, replace them.
and the throttle sensor
1
are loosened, the throttle sensor must be adjusted again.
1
and pull the connecting piece out of the
3
off the carburetor.
4
and the main air jet
5
8-6
.
2
.
6