Plena Power Amplifier | Installation and User Instructions | Installation
1 Remove the unit from the box, and discard the
packaging material according to local regulations.
Install unit in rack (optional)
The Plena Easy Line Power Amplifier is intended for
tabletop use, but you can also mount the unit in a
19" rack (see figure 3.1).
If you mount the unit in a rack, you must:
ensure that it does not exceed the overheating
temperature (55 °C ambient).
use the included Bosch mounting brackets
remove the 4 feet from the bottom of the unit.
figure 3. 1 : Installing the unit in a rack
Bosch Security Systems | 2008-02 | PLE-1P120-EU, PLE-1P240-EU en
1 Connect any additional equipment (see section 4.1
1 Make sure the voltage selector (115/230 VAC) is
correctly set for the country's main voltage
(see figure 3.2).
2 Make sure the power button on the front of the unit
is set to Off.
3 Connect the power cord to the mains connector and
plug it into the mains outlet.
figure 3.2: Power connection and voltage selector
Connect unit to mains
Potential equipment damage. Before
connecting power, always check the voltage
selector on the rear panel of the unit.
en | 11