Advertisement
Table of Contents
Plena Power Amplifier | Installation and User Instructions | Connections and settings
en | 14
4.1.2
100 V input
The 100 V input is used to connect directly to a 100 V
line (slave operation).
A 100 V input signal can be connected to the Euro style
pluggable screw terminal connector (2) at the rear of the
unit as shown in figure 4.2.
To adjust the volume of the input signal, turn the input
volume control (4) at the rear of the unit.
figure 4.2: Connecting a 100 Volt input signal
Bosch Security Systems | 2008-02 | PLE-1P120-EU, PLE-1P240-EU en
Advertisement
Table of Contents
Related Manuals for Bosch Plena Easy Line PLE-1P120-EU
Related Content for Bosch Plena Easy Line PLE-1P120-EU
- LBB 1930 100 V Slave Input
- PLENA LBB1938/30 Connecting Line Input And Loop-Through
- Rexroth RA 10 Series Variants For Wiring An Input Or In Parallel Operation
- Rexroth VT-VSPD Series Display/Input Keys And Connections Of The Controller Card
- PLENA Series Priority Microphone (Input 1)
- PLE-1P120-US Input
- LBB 1903/10 Setting The Vox For Microphone Input 1
- Plena PLE-2MA120-US Priority Microphone (Input 1)
- Plena LBB1930/20 Connecting Line Input And Loop-Through
- Plena PLE-1MA030-US Priority Microphone (Input 1)
- PLN-1LA10 Priority Input
- LBB 1920 Microphone Or Line Input
- PLE-2MA120-EU Loudspeaker Outputs 100 V
- PLE-1MA030-EU Loudspeaker Outputs 100 V
- Rexroth VT-VRPD-2 Display/Input Keys And Connectors On The Front Panel
- Plena Power Amplifier Connecting Line Input And Loopthrough