Page 1
If any defect develops during this period EARTHWAY will repair or replace this product or part at no charge provided the defect is not the result of mishandling or tampering. If advised by EarthWay that the product or part is to be returned, the shipping charges must be prepaid to EarthWay Products, Inc.
3. Establish the correct rate and then lock the stop in that position using the thumb wing nut on the setting control. OUNTING NSTRUCTIONS Position the M40 on the vehicle so that the vertical center frame brace is positioned at the edge of the vehicle, this will allow a full 180 degree spread pattern.
Use Caution ~ disconnect power supply. OPERATING INSTRUCTIONS: Before filling hopper, become familiar with the operation of this spreader. (Practice the following steps) 1. Connect only the black wire (ground) to the negative (-) post on the battery. Connect the other two wires to the positive (+) post on the battery.
Mounting Systems EarthWay recommends that the M40 be mounted into the bed of a vehicle or to a secure horizontal or vertical surface capable of hold- ing a 300lb weight. The hole location dimensions for reference are shown below.
Bristol, Indiana 46507 (574) 848-7491 www.earthway.com HOW TO ORDER SPARE PARTS All spare parts listed herein may be ordered direct from the manufacturer, EARTHWAY PRODUCTS,INC. Be sure to give the following information when ordering. 1. Model Number 2. Part Number 3.
Electromagnetic Compatibility. No alterations are to be made to the machine without prior con- sultation and approval of EarthWay Products, Inc. otherwise the Declaration may become inva- lid. This equipment must be commissioned, used and maintained strictly in accordance with the operating and maintenance instructions issued with the machine.