• The shortcuts (
path between two positions, crossing the open position if necessary, or always avoid the open position.
D i m m e r
The dimmer curve setting (
simulate tungsten dimming or
D i s p l a y
The display intensity (
display or manually set the intensity to a level from
The display on/sleep setting (
sleep 2 minutes (
press on any key or an error message will switch it on again.
To flip the display, press [Up] and [Down] simultaneously.
L a m p
There are two settings that modify lamp control: Automatic Lamp On (
(
!
When
lamp strikes automatically after the fixture is powered on. When
automatically when the fixture receives DMX data, and it extinguishes 15 minutes after DMX data is lost.
When
from striking at once. The delay is determined by the fixture address.
The DMX Lamp Off (
switches off the lamp. The special combination of DMX values listed on page 14 allows you to execute the
lamp-off command even when disabled.
D M X r e s e t
The DMX reset (
command is fully enabled. When set to
set to
C o l o r b l a c k o u t
The color blackout (
wheels deploy 3 seconds after dimmer blackout. The color filters absorb any tiny amount of light that may
escape past the dimmer.
The color wheels take a fraction of a second longer to open than the dimmer blades, however, so setting
this feature to OFF allows the fixture to snap open more rapidly after a blackout.
Readouts
T i m e
!
Under each item is a resettable (
accumulated hours/strikes since fabrication. To reset an increment counter, display it and then press [Up]
until it reads 0.
T e m p e r a t u r e
!
F i r m w a r e v e r s i o n
!
briefly at startup.
12
) setting determines whether the gobo and color wheels take the shortest
!
!
for more linear dimming.
!
!
), or 10 minutes (
).
is
, the lamp remains off until a "lamp on" command is received. When
is set to either
or
) setting allows you to enable (
) setting controls the behavior of the reset command. When set to
!
, the command must be sent for five seconds.
) setting enhances blackout effectiveness. When set to
!
provides readouts of fixture hours (
provides readouts of the head and base temperature in Celsius and Fahrenheit.
displays the version number of the installed firmware. The firmware version is also displayed
MAC 550 Profile
) provides two options for dimmer behavior. Select
) setting controls display brightness. Select
to
.
) determines whether the display remains on (
) after the last key press. If the display is in sleep mode, a
, the automatic lamp strike timing is staggered to prevent all lamps
) or disable (
, the command is disabled to prevent accidental resets. When
), lamp hours (
) increment counter and a non-resettable (
) and DMX Lamp Off
!
is set to
, the lamp strikes
) the DMX command that
), and lamp strikes (
) counter for total
to
for automatic
), or goes to
is
, the
, the
, the color
).