Information Readouts - Martin MAC 250 Krypton User Manual

where you want some fixtures to mirror the performance of others with the same DMX address, or when
fixtures are not oriented as programmed.
• , the pan/tilt speed menu, provides 3 settings:
PT SP
most applications.
• , the shortcuts setting which can be found under the PERS (personality) menu, determines whether
SC UT
the color and gobo wheels scroll past open when changing positions. When set to
a shortcut" and scroll through open when this is the shortest path to the next position. The wheels do not
scroll past open when
D I S P L A Y
The display menu (
the display remain lit, or OFF to extinguish the display two minutes after the last key press.
To flip the display for easier reading, press [up] and [down] simultaneously.
The display intensity setting (
automatic dimming of the display using the built-in light sensor, or manually select an intensity level from 10
to 100.
L A M P P O W E R
There are two settings that modify lamp control: Automatic Lamp On (
(
P E RS > DL oF
There are three options for automatic lamp control:
remains off until a lamp-on command is received from the controller. When
automatically after the fixture is powered on. When
when the fixture receives DMX data, and it extinguishes automatically 15 minutes after DMX data is lost.
When ALON is either ON or DMX, lamp strike timing is determined by the fixture address to prevent all
lamps from striking at once.
The DMX Lamp-Off setting effects how the lamp can be turned off. When
switched off by sending a DMX value from 248 to 255 on channel 1 for five seconds. When
the lamp-off command will not work unless special conditions are met. Refer to the DMX protocol.
R E S E T
The fixture can be reset from the controller if DMX reset (
, this command will not work unless special conditions are met. Refer to the DMX protocol.
OF F
D E F A U L T S E T T I N G S
The fixture can be reset to its factory default settings by selecting

Information readouts

P O W E R - O N H O U R S
Read the total number of hours the fixture has been on since fabrication (
and the number of hours on since the counter was last reset (
used to track maintenance intervals. Press [up] for 5 seconds while displayed to reset.
L A M P H O U R S
Read the total number of lamp hours since fabrication (
of lamp hours since the counter was last reset (
installing a new lamp. Press [up] for 5 seconds while displayed to reset.
provides better performance in applications where speed is most important.
F AS T
is set to OFF.
SC U T
) determines whether the display remains lit or not. Select
P E R S > d I S P
P E R S > d I N T
).
Control Panel
F A ST , N OR M a nd SL O W
) controls display brightness. You can select
P ER S> A LO N
, , and
O N O F F D M X
is set to
A L O N D M X
d L OF
P E RS >d R ES
dF S E> FA C T> LO A d.
I NF O >T IM E >H R S> RS E T
I NF O >T IM E >L HR > TO T L
I N FO >T I ME > L H R> R SE T
. is best for
N OR M
, the wheels can "take
O N
O N
A U T O
) and DMX Lamp-Off
. When is , the lamp
A L O N O F F
is , the lamp strikes
A LO N O N
, the lamp strikes automatically
is , lamp power can be
O N
d L OF
) is set to . If DMX reset is
5 S EC
I NF O> T IM E> H RS >T O TL
). This can be
), and the number
). Reset this counter after
to have
for
is ,
OF F
),
11