ITS Telecom CGW-T Installation And Programming Manual page 30

Operation
Time-out value in
seconds. When an
insufficient number of
digits are dialed, this
defines the period of time
that the device will wait
until timeout (inter-digit).
Reverse Polarity
The unit may be set up to
send a "reverse polarity"
command to the PBX, in
case a "call answer" is
detected. This parameter
is useful if call
accounting software is
active.
Output Volume Control
24
Command
*310 + X
where:
X = 2 - 9
*320 + X
where:
X = 0 – 2
0 = No reverse polarity
1 = Reverse polarity only on
Outgoing calls
2 = Reverse polarity for
Incoming and Outgoing Calls
*330 + X
where:
X = 0 – 7 (CDMA)
X = 0 – 9 (GSM)
CGW-T/TS/D Installation and Programming Manual
Default
3 (sec.)
2
5