ACN IRIS 3000 Quick Start Manual page 6

2. Installation without Router
Follow these instructions if your computer is connected directly to your
broadband connection via a modem.
1. Connect the handset to the connection point located on the side of
your Videophone.
2. Unplug the existing Ethernet cable from your computer that connects your
Cable/DSL modem to your computer. The other end of this cable should stay
attached to your modem. Connect the Ethernet cable that you unplugged from
your computer to the WAN port of your Videophone.
3. Connect one end of the new Ethernet cable that came with your Videophone,
to the LAN port of the phone. Connect the other end to the Ethernet port of
your computer.
4. Connect the Power Adapter to the power port and then plug it into an electrical
outlet. Note: Do not use power adapters from other devices.
5. Turn the Power Switch on your Videophone to ON. You will see a status line
on your screen as your phone goes through setup. Once this is complete, the
register light on the front of your phone will turn green, and your Videophone
is ready for use.
Note: Simultaneous use of the computer and the Videophone will affect the quality of
the connection.
Set-up Diagram
Cable or DSL Modem
6
Computer
2
3
1
Videophone