Section One: Assembly Instructions - Traeger BBQ055 Owner's Manual

SECTION ONE: ASSEMBLY INSTRUCTIONS

MOUNTING LEGS AND WHEELS:
LEG WITH
BOTTOM CAP
NOTE: Install all Leg Screws and Nuts, 3 in ea
G rill upright to level and then tighten all nuts.
M OUNTING PELLET HOPPER/BURNER:
NOTE: DO N OT remove the white, square Burner Gasket (86) from the Hopper/Burner
(37).
Slide the Hopper/Burner (37) square tube into the square opening located on the left
1)
side of the Grill Body (3). Gently push the Hopper/Burner (37) into the Grill
until the Hopper/Burner (37) is snug against the end of the Grill Body (3).
2 ) Align the bolt holes in the Grill Body (3) with the Nut Serts in the Hopper/Burner (37).
3) Install a Flat Washer on each of the four Hex Head Bolts. From the inside of the G
Body (3) install these Bolts with Washers into the Hopper/Burner
Tighten all four Bolts – DO NOT OVER TIGHTEN THE BOLTS.
AXLE ROD
PHILLIPS SCREWS
WITH FLAT WASHERS
AND HEX NUT
(3 PER LEG)
LEG WITH HOLES FOR
A XLE/WHEELS
FLAT WASHER BETWEE
WHEEL AND LEG AND
BETWEEN WHEEL AND
N YLOCK NUT OUTSIDE
ch Leg, LEAVING NUTS LOOSE. Set
S INSIDE
N
Body (3)
rill
(37) Nut Serts.