Traeger BBQ055.04 Owner's Manual
  1. Manuals
  2. Brands
  3. Traeger Manuals
  4. Grill
  5. BBQ055.04
  6. Owner's manual

Traeger BBQ055.04 Owner's Manual

Residential pellet grill-smoker
Hide thumbs

Advertisement

Table of Contents

OWNER'S MANUAL
BBQ055.04
RESIDENTIAL PELLET GRILL-SMOKER
FOR OUTDOOR USE ONLY!
WARNING!
DO NOT STORE OR USE COMBUSTABLE MATERIALS
NEAR THIS APPLIANCE!
USE ONLY TRAEGER BRAND HARDWOOD
BBQ PELLETS IN THE OPERATION OF THIS UNIT.
"TASTE THE DIFFERENCE"
"

Advertisement

Table of Contents
loading

Related Manuals for Traeger BBQ055.04

Summary of Contents for Traeger BBQ055.04

  • Page 1 OWNER’S MANUAL BBQ055.04 RESIDENTIAL PELLET GRILL-SMOKER FOR OUTDOOR USE ONLY! WARNING! DO NOT STORE OR USE COMBUSTABLE MATERIALS NEAR THIS APPLIANCE! USE ONLY TRAEGER BRAND HARDWOOD BBQ PELLETS IN THE OPERATION OF THIS UNIT. “TASTE THE DIFFERENCE” “...
  • Page 2 INTRODUCTION Congratulations on your purchase of this Traeger Wood Pellet Grill, Model BBQ055.04. With proper set-up, operation and maintenance, the Grill will provide you with delicious food and years of cooking enjoyment. NOTE: NUMBERS FOLLOWING PART NAMES THROUGHOUT THIS MANUAL REFER TO THE COMPONENT DIAGRAM.

  • Page 3: Section One: Assembly Instructions

    SECTION ONE: ASSEMBLY INSTRUCTIONS MOUNTING LEGS AND WHEELS: 1. Insert Left Front Leg (119) onto Grill Frame Assembly (3) so the holes align and insert 3 each 1/4-20 x .750 screws (140). Then from the inside of the skirt secure using 3 each Washers (142) and nuts (141) do not tighten the nuts until the grill is upright.
  • Page 4 POSITIONING HEAT BAFFLE AND GREASE DRAIN PAN Become familiar with how each component fits inside the Grill. RECOMMENDATION for ease of clean-up: Line the Grease Drain Pan (163) with heavy- duty aluminum foil. Be sure the edges and ends of the foil are tight against the bottom of the Grease Drain Pan (163).

  • Page 5: Section Two: Initial Firing Instructions

    Hot Rod is getting hot. DO NOT TOUCH IT! Turn the Temperature/Dial to Shut Down Cycle. 4) Fill the Pellet Hopper with TRAEGER BBQ PELLETS. WARNING! USE ONLY TRAEGER BRAND BBQ PELLETS, which are specifically made to work in our Grills. NEVER use heating fuel pellets in the Grill.

  • Page 6: Section Three: Subsequent Start-Up

    Door and set the temperature/Dial to any cooking setting desired. 5) If this procedure is not successful, see Section Six: FREQUENTLY ASKED QUESTIONS for troubleshooting tips or contact Traeger Technical Support (Section Seven) to help diagnose the problem before proceeding to the MANUAL LIGHTING INSTRUCTIONS below.
  • Page 7 2) Open the Pellet Hopper and fill with TRAEGER BBQ PELLETS. WARNING! USE ONLY TRAEGER BRAND BBQ WOOD PELLETS, which are specifically made to work in our Grills. NEVER use heating fuel pellets in the Grill due to potential hazardous contaminants and additives that may be present.

  • Page 8: Section Four: Operating Tips

    “hold” foods at approximately 180 to 200 degrees F. 2) Your TRAEGER PELLET GRILL should never be moved while it is hot. If you are transporting your Grill in a vehicle after cooking on it, make sure the fire is completely out and the Grill is COLD before placing it in any vehicle.

  • Page 9: Section Five: Maintaining Your New Grill

    Pellet Hopper. Wood pellets, when wet, expand greatly and will jam you Auger. A TRAEGER GRILL COVER to protect the Grill is highly recommended! Covers are available from your local Traeger Dealer, or log on to our Web Site – www.traegergrills.com.

  • Page 10: Section Six: Frequently Asked Questions

    -- the Hot Rod needs to be replaced. If one or both are not operating, contact Traeger Technical Support (SECTION SEVEN) for additional troubleshooting help. Contact your Traeger Dealer or the Traeger Parts Department (SECTION SEVEN) to place an order.
  • Page 11 Contact your Traeger Dealer or the Traeger Parts Department (SECTION SEVEN) to place an order. c) If the fan blade turns a bit and then stops, continue watching and turn the Switch to OFF. If the fan blade UNWINDS slightly, this indicates a jam in the Auger system which will need to be cleared.
  • Page 12 WHERE CAN I GET A NEW PART FOR MY GRILL? Check with your Traeger Dealer. They may have the part in stock or can order the part for you. Or you can contact the Traeger Parts Department (SECTION SEVEN) to place an order.

  • Page 13: Section Seven: Traeger Support

    Parts are identified in the front of this manual on the COMPONENT DIAGRAM PAGE. To order parts: Call, E-mail or write to your Authorized Traeger Dealer or Traeger Pellet Grills. Please provide your name, phone number, address, Model and Serial Number of the Grill (located on a label inside the Hopper Lid), along with the part identification.
  • Page 14 BBQ055.04 COMPONENTS DIAGRAM...
  • Page 15 BBQ055.04 PARTS LIST Item Description Item Description Grill Frame Assembly SUB018 Hopper Burner Gasket INS144 Door Assembly SUB120 Hopper Assembly SUB021 Dome thermometer 2” BAC256 Hopper Lid Assembly SUB022 Nut 10-32 Hex Zinc HDW136 106 Control 3 Speed W/SDC BAC002...
  • Page 16 BBQ055.04 WIRING DIAGRAM...

Table of Contents