Table of Contents
Advertisement
O-4
Clearing the Current Combination and Setting a New Combination
Note: Align the code gear pockets with the "L" shaped legs.
Depress the combination change button (i) located on top
of the combination chamber and release.
Rotate the reset cam back toward you with your finger
(toward the key stems) as far as it will go and release.
Enter your new combination by depressing the key stem
corresponding to the first number (1 through 5) of your
combination. For example, if the new combination is 3-2-5,
then you would depress 3 first, then 2 and finally 5. Record
this new combination for future reference.
Push the shoulder (j) at the bottom of the Unlocking slide up toward the
combination change button and release. If each of the 5 "L" shaped legs of
the unlocking slide engages snugly inside its corresponding code gear pocket,
then it confirms that the new combination has been successfully changed.
Rotate the reset cam (g) back toward you and release.
Note: If all 5 "L" shaped legs do not align fully with their corresponding
code gear pockets, repeat the procedures O-3 and O-4.
O-5
Reinstalling chamber assembly into lock and retesting
Reinstall the 3-sided dust cover over the combination chamber with the
2 small Phillips screws removed. (May be 1 screw in newer models)
Reinstall the combination chamber assembly to the base plate with the
2 Phillips screws removed.
Reinstall the base plate on to the outside lock assembly with the 2
Phillips screws removed. Make sure all parts have been reinstalled
correctly.
O-6
Reinstall lock on door by following the procedures in Sections E and F
of this manual.
O-7
Retest new combination with lock on door by entering the new
numbers followed by the "ENTER" button and rotating the outside
lever/knob. The lock should open and the latch should retract.
For technical assistance please call
1.800.849.TECH (8324) or 336.725.1331
20
e
i
h
a
g
c
j
f
Hide quick links:
Advertisement
Table of Contents
