Support Pin Removal; Cooling Fan Removal - Wolf Induction Cooktop Technical & Service Manual

To avoid Injury from sharp edges, always wear
gloves when handling sheet metal components.

Support Pin Removal

1. In order to replace a defective pin you must fi rst
remove the Pin Support Bracket from the Inductor
Pan Assembly. (See procedure previous page)
2. Using a 7/16" open end wrench and a 3/8" socket
or nut driver to remove the fastening nut from the
bottom of the bracket. (See Figure 4-10)
3. When installing the new pin in the bracket be certain
that the pin is fully seated in the bracket before
tightening nut.
Cooling Fan Removal / Replacement
The fan is serviceable from the bottom of the cooktop if
space allows. If space does not allow, you will need to
remove the cooktop from its installation.
NOTE: Refer to the installation section of this manual
or the Installation Guide included with the cooktop for
additional information needed.
NOTE: Care must be taken to protect glass surface from
scratches or damage. Place on protective surface.
1. After the unit has been removed from its installation
access to the fan is gained from the bottom of the
unit.
2. Remove the three mounting screws from the fan
bracket using a Phillips Screw Driver. (See fi gure
4-11)
3. The fan can now be removed from the inductor pan
assembly by carefully lifting up on the fan bracket
and sliding the tab from the slot in the bottom of the
pan.
4. Next you will need to disconnect the Molex plug that
supplies power to the fan for operation. (See Figure
4-12)
Figure 4-11 Remove Screws that fasten fan bracket.
Induction Cooktop
Figure 4-8 Remove the support screw.
Figure 4-9 Remove the 11/32" nut.
Figure 4-10 Remove the nut from the support bracket.
Figure 4-12 Disconnect Molex for fan power supply.
4-5
Access and Removal