Control Board; Inductor Plate; Pin Support Bracket - Wolf Induction Cooktop Technical & Service Manual

Access & Removal
TO AVOID ELECTRICAL SHOCK OR DAMAGE TO
ELECTRONIC BOARDS, POWER TO THE UNIT MUST
BE DISCONNECTED BEFORE ATTEMPTING TO
REMOVE INTERNAL CONTROL COMPONENTS.
Inductor Plate (Generator) Removal
The cooktop will need to be removed from its installation in
order to service the inductor assembly.
NOTE: Refer to the installation section of this manual or the
Installation Guide included with the cooktop for additional
information needed.
NOTE: Care must be taken not to apply pressure to the
ribbon cables as the inductor plate is lifted.
1. After the unit has been removed from its mounting the
glass top must be removed. (See glass top removal
above)
2. The inductor plate just rests on springs that set over
the alignment pins. Once the glass top is removed the
inductor plate can be lifted off the pins.
3. Disconnect the ribbon cable/s for the inductor plate
from the control board. NOTE: Depress the connector
tab when unplugging or you could damage connector
or board. (See Figure 4-5)
4. Disconnect molex connector/s that provide power to
the inductor plate. (See Figure 4-6).
5. Disconnect the molex plug that provides fi ltered power
to the control board. (See Figure 4-7).
6. Now the inductor plate can be lifted out of the unit.
NOTE: If you are replacing ribbon cable to the inductor
board the orientation (at plate connector) will always
require the ribbon extend toward the outer edge of the
board.
Pin Support Bracket Removal
1. To gain access to the pin support bracket the inductor
plate/s must be removed. (See Inductor Plate Removal
above)
2. Remove the Phillips Screw that secures the bracket to
the side of the inductor pan assembly. (See Figure 4-8)
3. Remove the nut that secures the bracket to the bottom
of the inductor pan. (See Figure 4-9)
4. The bracket can now be lifted out of the pan assembly.
5. When reinstalling you will need to secure the Phillips
screw to the side before tightening the nut on the
bottom of the pan.
Induction Cooktop
Depress this TAB Depress this TAB
Figure 4-5 Disconnect the ribbon cable running to the
Figure 4-6 Disconnect Molex Plug/s that supply Inductor
4-4

Control Board.

Plate Power.
Figure 4-7 Disconnect Molex for Filtered Power.