Component Access And Removal - Wolf CT30I/S Instructions Manual

Component Access & Rmvl

COMPONENT ACCESS AND REMOVAL

This section explains how to access and remove components from a Wolf Induction cooktop. Depending on which
component you are going to access or remove in the following sections, you may have to remove some components
first. Refer to the appropriate section in this manual that explains how to access and remove those various compo-
nents. When reassembling, reverse the steps that were used to access and remove the components.
NOTE: Before attempting to access or remove any components from a Wolf appliance, take note of the
WARNINGS and CAUTIONS below.
• TO AVOID ELECTRIC SHOCK, POWER TO THE UNIT MUST BE DISCONNECTED WHENEVER SERVICING
AND/OR ACCESSING COMPONENTS.
• KEEP IN MIND THAT GLASS TOP SURFACES AND COMPONENTS GET HOT DURING USE OF THE APPLI-
ANCE.
• IF IT IS NECESSARY TO REMOVE A UNIT FROM ITS INSTALLATION, REMEMBER THAT THE UNITS ELEC-
TRICAL POWER CORD IS HARD WIRED AND COMPLETE REMOVAL WILL BE LIMITED. PULLING A UNIT
FROM ITS INSTALLATION SHOULD ONLY BE PERFORMED BY AN AUTHORIZED SERVICE TECHNICIAN
OR INSTALLER.
When working on the cooktop and components, be careful when handling sheet metal parts. There may be
sharp edges present.
#821684 - Revision B - March, 2013
Induction Cooktop (CTI) Series
Induction Cooktop (CTI) Series
4-2