Network Deployment - Vivotek IP8151 User Manual

Network Deployment

Setting up the Network Camera over the Internet
This section explains how to configure the Network Camera to an Internet
1. If you have external devices such as sensors and alarms, connect them to the general I/O
terminal block�
2� Connect the camera to a switch via Ethernet cable�
3� Connect the power cable from the Network Camera to a power outlet�
NOTE
► There are two power supply modes-- feed power from the Network Camera to the external
DO device or feed power to the external Do device from an external power supply. Please
follow the instruction below to connect the external DO device:
1� Feed power by the Network Camera - connect to pin 1 & pin 2
1: Power +12V
2: Digital output
3: Digital input
4: Ground
2. Feed power by an external power supply - connect to pin 2 & pin 4
For 5V Network Camera: < 5V, 100mA; for 12V Network Camera: < 12V, 100mA
1: Power +12V
2: Digital output
3: Digital input
4: Ground
There are several ways to set up the Network Camera over the
up the Network Camera behind a
to use PPPoE�
3
2
router� The second way is to utilize a static
connection�
1
1: Power +12V
2: Digital output
3: Digital input
4: Ground
5: AC 24V
6: AC 24V
7: RS485+
8: RS485-
Ethernet Switch
Internet� The first way is to set
IP� The third way is
User's Manual - 7
VIVOTEK