Fig.5
1. Loosen the clamping level(A)and feed the
saw band guide (B)as far as possible along
the workpiece.
2. Tighten the clamping lever(A); SEE FIG.5
Changing the cutting angle
!
Danger!
Before adjusting the power tool, always press
the main switch
Off/0.
The cutting angle can be adjusted steplessly
5 (
from
0 to 4
end stop) without interuption.
Fig.6
B
A
1. Loosen the clamping lever(A) and set the
swivel support (B) to the required cutting
angle. Use the scaling on the machine
tables as an adjustment aid.
2. Re-tighten the clamping lever. SEE FIG.6
Changing the saw band
!
Danger!
Before adjusting the power tool, always press
the main switch
plug.
!
Caution!
A
Risk of injury! Wear protective gloves!
B
1. Press the main switch Off/0 and pull out
the mains plug.
2. Loosen the clamping lever(A, in Fig.5) and
push back the saw band guide (B,
as far as the stop.
3. After loosening the 4 screws, remove the
protective housing from the saw frame.
4. Release saw belt tension by swivelling the
tension lever clockwise.
Fig.7
5. Slacken the hex-head nut (a) on both outer
saw band guides.
6. Rotate screw (b) slightly in an anti-
clockwise direction until the saw band is
C
released.
7. First take the saw band off the guide
rollers and then out of the guides.
13
Off/0 and
pull out the mains
SEE FIG.7
in Fig.5)