Predelivery Inspection; Operating Engine With The Boat Out Of The Water - Mercury MerCruiser Product Applications Manual

Predelivery Preparation

Predelivery Inspection

It is the boat manufacturer's responsibility to perform the checks called out on the checklist
included in the literature packet with each engine (see the copy at the end of this section)
to verify that the power package has been properly installed and is performing correctly.
Each check on the list should be checked-off to indicate to the dealer and customer that it
has been completed. Some of the checks may require that you consult the installation
manual or the Operation, Maintenance, and Warranty manual for specific information or
procedures.
Avoid engine overheating. If engine is to be tested on land, water must be supplied to
the seawater pickup pump. Do NOT operate the engine above 1500 rpm.
If for some reason it is not possible to perform some of the checks at your facility (i.e.
performance checks), arrangements should be made with the dealer to ensure that these
checks are completed before delivering the boat to the customer. Financial compensation
to the dealer for performing these checks is left up to the discretion of the boat
manufacturer.
Once the checks are completed, the power package must be prepared for shipment.

Operating Engine With the Boat out of the Water

Avoid Injury: If engine is to be tested with the boat out of the water, the propeller must
be removed to avoid injury.
Overheating from insufficient cooling water will cause engine and drive system damage.
Ensure that there is sufficient water always available at water inlet holes during operation.
1. Disconnect the water inlet hose for the seawater pickup pump. Connect the water hose
using appropriate hardware.
Typical composite seawater pump
Page 10A-2
a
7638
a - Seawater inlet hose
CAUTION
!
WARNING
!
CAUTION
!
a
Typical brass seawater pump
90-863758060 AUGUST 2006
9361