Control - Chroma Color Force 12 User Manual

The Color Force 12 fixture has the 'chevron' markings stamped on both ends and printed at the rear enclosure to indicate the
side of the fixture that should be adjacent to the wall or cyclorama.
2.6

Control

Color Force 12 fixture can operate as a stand-alone unit or be controlled remotely via ANSI E1.11 USITT DMX512-A protocol. The
control functions can be accessed through the LCD display at the rear of the fixture with 4 push buttons.
Push button operation:
Power-Up Display:
On power-up and home position, the Main Menu display shows the model name, software version, the DMX address, current
assigned mode and the number of channels the Color Force 12 is set.
Display Mode:
The LCD is backlit when you access the menus. This will turn off when left undisturbed for 5 seconds.
Control Options:
3 channel HSI (Hue, Saturation and Intensity) gives 2 colour channels for hue and saturation and a separate intensity channel. A
separate definable intensity channel is particularly useful when creating intensity chases or when the grand master is used. The
hue channel has 255 different colours available and the saturation channel specifies the saturation level of that colour. The
saturation channel is fully saturated at full. White is achieved with the intensity channel to full and the saturation channel at zero.
3 channel RGB (Red, Green, Blue with *Magic Amber™) is the more traditional way of controlling colour changing LED fixtures.
Each of the three control channels directly affects the intensity of the corresponding LED. Colour is mixed by adjusting the levels
of the three primary colours. White is achieved with all channels at full including Magic Amber.
Color Force 12 User Manual
Control Function
Exit Back to previous menu
Up Arrow Increases (+) the mode level or value
Down Arrow Decreases (-) the mode level or value
Back Arrow (Enter) Stores the menu choice
www.chroma-q.com
6 V1.8 August 2014