Chroma Color Force 12 User Manual page 10

Press Up/Down buttons to access "Look Store", and press Enter,
Press Up/Down buttons to the desired Look and press Enter to access the memory data.
The data is presented as two numbers separated by a letter "c". The number to the left of the "c" is the channel
number and to the right is the channel level. Pressing Up/Down up to the far end will show the Mode at which the
selected Look was programmed.
To edit the Mode of a selected Look:
Press Up/Down buttons to access "Look Store" and press Enter,
Press Up/Down to the desired Look and press Enter to access the memory data,
Press Up/Down buttons up to the far end until Mode number is shown and press Enter,
Press Up/Down buttons to adjust the Mode number,
Press Enter to toggle back to the channel numbers.
To edit the channel numbers and levels of a selected Look:
Press Up/Down buttons to access "Look Store" and press Enter,
Press Up/Down buttons to the desired Look and press Enter to access the memory data,
Press Up/Down buttons and select the channel number,
To edit the channel level, press Enter and use the Up/Down buttons to adjust the level (shown as 0-255),
Press Enter to toggle back to the channel number,
When the desired effect is created press Enter for 2 seconds to save the edited Look.
Technical
In this mode,
Frequency settings of the unit can be changed,
•
Software for the LED engines can be uploaded
•
ETC compatible settings can be activated.
•
Press Up/Down to access "Technical",
Press Up/Down to select either "Frequency" or "Upload Engines" or "ETC compatible".
Frequency: Frequency: Frequency: Frequency:
The Color Force 12 has four frequency settings available - 600, 1200, 2400, 4800.
This allows for the LED scan rate to be synchronised with the video camera and avoid a flickering effect.
Press the Up/Down buttons to select the desired frequency,
Press Enter for 2 seconds to save settings.
Upload Engines: Upload Engines:
Upload Engines: Upload Engines:
Pre-programmed engines can be uploaded to the Color Force 12 from the Chroma-Q Uploader:
Press Enter, Up/Down buttons to select "Upload Engines" then press Enter, and the display will show "Ready",
Connect an XLR 5-pin cable from the Uploader to the unit,
Press the "GO" button once to execute the uploading - red indicator light on the "GO" button will blink,
The Uploader display will show a simulated arrow moving from left to right indicating the uploading process,
All the green LEDs of the unit will light up (low intensity) to indicate completion of a successful Upload and the
Uploader display will show "DONE",
Power-cycle the unit.
(See Quick Start Guide of the Chroma-Q Uploader)
ETC compatible: ETC compatible:
ETC compatible: ETC compatible:
Colour output of the Color Force fixture can be set to match the Color Picker feature in the ETC Eos consoles.
Press Up or Down buttons to select "ETC compatible",
Select On or Off,
Press Enter for 2 seconds to save.
Color Force 12 User Manual
www.chroma-q.com
9 V1.8 August 2014