Horn Alert/P.a. Relay Unit; Installing The Kap-2 Unit In The Transceiver - Kenwood NX-700 Service Manual

NX-700/700H
2. Horn Alert/P.A. Relay Unit (KAP-2: Option)
The Horn alert (max. 2A drive), Public address and Exter-
nal speaker function are enabled by installing the KAP-2 in
the transceiver.

2-1. Installing the KAP-2 unit in the transceiver

(The kit A is not used in the KAP-2 accessories)
1. Remove the cabinet, top packing and shielding plate of
the transceiver.
2. Set the KAP-2 relay unit jumper pins according to the
purpose of use.
3. Remove the 6-pin jumper connector inserted in the TX-
RX unit (A/2) connector (CN705). ( q )
4. Insert one side of the lead wire with connector
(E37-1114-05) into the relay unit connector (CN3) ( w )
and the other side into the TX-RX unit (A/2) connector
(CN705) ( e ).
CN705
FIg. 2-1
8
INSTALLATION
5. Place the relay unit at the position shown in Figure 2-2
6. Remove the cap on the rear of the chassis by pushing it
7. Pass the 6-pin connector of the cable (E37-1113-15)
8. Rotate the bush of the cable 90 degrees counterclock-
9. Insert the 6-pin connector of the cable into the connector
Note: You must setup using the KPG-111D.
E37-1114-05
CN3
CN705
FIg. 2-2
E37-1113-15
FIg. 2-4
and secure it to the chassis with a screw.
from the inside with your fi nger. ( r )
through the chassis hole ( t ) and insert the bush into
the chassis hole.
wise as viewed from the rear of the chassis. ( y )
(CN2) of the KAP-2 relay unit. ( u )
CN2
FIg. 2-3