Kenwood NX-700 Service Manual page 53

Item
Panel test mode
2. Low 1) Adj item: [LOLMT]
Transmit Adjust: [✳✳✳✳]
Power 2) Adj item:
Limit [L LOLMT]→
adjust [L' LOLMT]→
[C LOLMT]→
[H' LOLMT]→
[H LOLMT]
Adjust: [✳✳✳✳]
PTT: ON
Press [ ] key to store
the adjustment value.
3. High 1) Adj item: [HIPWR]
Transmit Adjust: [✳✳✳✳]
Power 2) Adj item:
adjust [L HIPWR]→
[L' HIPWR]→
[C HIPWR]→
[H' HIPWR]→
[H HIPWR]
Adjust: [✳✳✳✳]
PTT: ON
Press [ ] key to store
the adjustment value.
4. Low 1) Adj item: [LOPWR]
Transmit Adjust: [✳✳✳✳]
Power 2) Adj item:
adjust [L LOPWR]→
[L' LOPWR]→
[C LOPWR]→
[H' LOPWR]→
[H LOPWR]
Adjust: [✳✳✳✳]
PTT: ON
Press [ ] key to store
the adjustment value.
ADJUSTMENT
Condition
PC test mode
equipment
1) Adj item: [Low Trans- Power
mit Power Limit] meter
2) Adj item: [Low], Ammeter
[Low'], [Center],
[High'], [High]
PTT: Press
[Transmit] button.
Press [Apply All]
button to store the
adjustment value.
1) Adj item: [High
Transmit Power]
2) Adj item: [Low],
[Low'], [Center],
[High'], [High]
PTT: Press
[Transmit] button.
Press [Apply All]
button to store the
adjustment value.
1) Adj item: [Low
Transmit Power]
2) Adj item: [Low],
[Low'], [Center],
[High'], [High]
PTT: Press
[Transmit] button.
Press [Apply All]
button to store the
adjustment value.
Measurement
Test-
Unit Terminal Unit
ANT
NX-700/700H
Adjustment
Parts Method
[Panel 15.0W K ±1.0W
tuning 25.0W HK
mode] [PC test mode]
[ ],[ ] Press [Apply All]
button to store the
[PC test adjustment value
mode] after all adjustment
[ ],[ ] point was adjusted.
CAUTION!
Do not attempt to
adjust the transceiv-
er's transmit output
power beyond its
specifi cations.
If the transceiver
is adjusted beyond
the specifi cations, it
may cause deterio-
ration of the parts
reliability and the
output power may
be lowered sud-
denly and unstable.
The transceiver may
be also extremely
hot.
30.0W K ±1.0W
50.0W HK 9.0A or less K
13.0A or less HK
[PC test mode]
Press [Apply All]
button to store the
adjustment value
after all adjustment
point was adjusted.
5.0W K ±0.5W K,
10.0W HK ±1.0W HK
5.0A or less K
8.0A or less HK
[PC test mode]
Press [Apply All]
button to store the
adjustment value
after all adjustment
point was adjusted.
Specifi cations /
Remarks
53