Transmitter Section - Kenwood NX-700 Service Manual

NX-700/700H
Item
Panel test mode
5. Frequency * The Frequency
adjust adjustment can be
performed only in
PC test mode.

Transmitter Section

Item
Panel test mode
1. High 1) Adj item: [HILMT]
Transmit Adjust: [✳✳✳✳]
Power 2) Adj item:
Limit [L HILMT]→
adjust [L' HILMT]→
[C HILMT]→
[H' HILMT]→
[H HILMT]
Adjust: [✳✳✳✳]
PTT: ON
Press [ ] key to store
the adjustment value.
52
ADJUSTMENT
Condition
PC test mode
equipment
1) Adj item: SSG
[Frequency]
2) CH-Sig: 1-1
SSG output :
–20dBm (CW (with-
out modulation))
Caution:
Perform the frequency
adjustment under the
following conditions.
• Temperature range
of +23˚C to +27˚C
(+73.4˚F to +80.6˚F).
(The temperature
is displayed on the
Frequency adjustment
screen of the KPG-
111D and the LCD of
the transceiver.)
• Use an accuracy of
0.003ppm for the
SSG. (Use a standard
oscillator if necessary.)
Condition
PC test mode
equipment
1) Adj item: [High Trans- Power
mit Power Limit] meter
2) Adj item: [Low], Ammeter
[Low'], [Center],
[High'], [High]
PTT: Press
[Transmit] button.
Press [Apply All]
button to store the
adjustment value.
Measurement
Test-
Unit Terminal Unit
ANT
Measurement
Test-
Unit Terminal Unit
ANT
Adjustment
Specifi cations /
Parts Method
[ ] [PC test mode] [PC test mode]
Press [Start] button "IF20" value =
of "Auto Tuning". Within 0±12 digits.
Press [Apply] button The value of "IF20"
to store the adjust- will become around
ment value after the "0" after the adjust-
automatic adjust- ment was fi nished.
ment was fi nished. Frequency is adjust-
ed under receiving
condition with SSG.
Adjustment
Specifi cations /
Parts Method
[Panel 33.0W K ±3.0W
tuning 53.0W HK
mode] [PC test mode]
[ ],[ ] Press [Apply All]
button to store the
[PC test adjustment value
mode] after all adjustment
[ ],[ ] point was adjusted.
CAUTION!
Do not attempt to
adjust the transceiv-
er's transmit output
power beyond its
specifi cations.
If the transceiver
is adjusted beyond
the specifi cations, it
may cause deterio-
ration of the parts
reliability and the
output power may
be lowered sud-
denly and unstable.
The transceiver may
be also extremely
hot.
Remarks
Remarks