Initial Parameter Setup (Users Set Up) - Skyrc Quattro B6AC Instruction Manual

INITIAL PARAMETER SETUP (USERS SET UP)

By default, this charger will be set to typical user settings when it is connected to DC
11~18V for the first time. The screen displays the following information in sequence and
the user can change the parameter on each screen.
If you need to alter the parameter value in the program, press "Start/Enter" key to make it
blink then change the value with "INC" or "DEC" key. The value will be stored by pressing
"Start/Enter" key once.
USER SET
PROGRAM->
INC
LiFe
V.Type 3.3V
- +
DEC INC
DEC INC
LiPo/LiIo/LiFe
CHK Time 10min
INITIAL PARAMETER SETUP (USERS SET UP)
User setup starting screen.
The screen displays the nominal voltage of Lithium battery. There are
three kinds of Lithium battery: LiFe(3.3V), Lilo(3.6V) or LiPo(3.7V).
This is very important so you have to check the battery carefully and
set it up correctly. If it is different from correct value the battery may be
exploded during charge process.
SKYRC QUATTRO B6 recognize the cell count of Lithium battery
automatically at the beginning of charge or discharge process to avoid
from erroneous setting by user. But deeply discharged battery can be
perceived incorrectly. To prevent the error, you can set the time term to
verify the cell count by the processor. Normally, 10 minutes are
enough to perceive the cell count correctly. For the battery of larger
capacity, you may extend the time term. But if you set the time term to
long for the battery of smaller capacity, the charge or discharge
process can be finished within the time term with the erroneous cell
count. This may cause the fatal result. If the processor recognizes the
cell count incorrectly at the beginning of charge or discharge process,
you may extend the time. Otherwise, you had better use with the
default value.